Knowledgebase
|
Why don't I see the heat balance simulation results (walls, glazing, roof etc gains)
Posted by Andy Tindale on 08-Oct-10 09:33 PM
|
|
|
In simulations, the surface fabric and solar heat transfer output is controlled by the Surface heat transfer incl solar output option. In versions 2.2 and later of DesignBuilder this output is now switched off by default to reduce the size of the output data set. This in turn speeds up results reading after simulations and reduces the likelihood of an error reading results for long simulation periods. To see the surface heat transfer outputs switch on the Surface heat transfer incl solar output option and re-simulate. | |
|
|